X10 Community Forum
🎭Entertainment => Entertainment General => Topic started by: bnocturnal on April 07, 2007, 10:17:39 AM
-
Hello,
I was wondering if anyone here would know how to reset the "PC" button on the Anywhere remote (UR81A) back to its original setting of sending RF codes?
The directions in the manual say to "Hold Setup until LED lights, Press 'PC', then enter '0','1','3''
Unfortunately, that doesn't work! :-(
I found another post elsewhere that suggested the code may be "580", but that also did not work.
Currently, I am letting the remote sit without batteries in hopes of resetting it.... but that apparently takes much longer than the 90 seconds they warn you about! (That previous post mentioned that it took 24 hours.)
Thanks,
Dave