X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: sam molone on May 15, 2007, 09:04:36 PM
-
I have my CM15A set to house code "B" but all my "B" modules show 0% and off when I start AHP.
Also, I want to brighten to 100% but it will only let me brighten to 99% and if in the macro I set it to go full on after the brightening then it just jumps right to full on?
The Dim macro seems to work fine, I can dim to -99% and then shut completely off in the macro but the brighten macro does not follow this same reasoning? ???