X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => PanTilt Pro => Topic started by: Soppa on September 18, 2007, 08:49:37 AM
-
Hey I ask that, is there any drivers or software that I can use different camera or videosource for Pan Tilt Pro software??
Do you have any ideas to do so??
My remote control CM19A works fine with ninja but video quality is poor (Trust 1.3Mpixel webcamera 1280x1024 15fps, 800x600 30fps). Other video softwares image quality are good with this camera.
Pan Tilt Pro software doesn't recognise EasyCap AV/USB adapter.
Are there coming new software/driver updates which replaces these problems or could you give some advices for me??
The Best Regards by Soppa
-
There is other software out there depending what you'd like it to do !
Just about all the X10 software requires the VA11A capture device!
I doubt any new software updates are coming any time soon for the Pan N Tilt Pro
Since the CM19A will work with the Active Home Pro SDK it is possible a program made with it will control and view your cams!
PC Companion (http://www.angelfire.com/in2/ontkoi/X10AHP/PcCompanion.html) should do it although you'll need the SDK Redistributable Components
(http://www.angelfire.com/in2/ontkoi/X10AHP/ahscript_setup.x10) as well!
Note: Save the ahscript_setup.x10 down load file as ahscript_setup.exe then install it!