X10 Community Forum
🖥️ActiveHome Pro => Smart Macros => Plug-ins => User-Designed Working Macros => Topic started by: Tuicemen on October 23, 2007, 06:25:22 PM
-
This is NOT a place to post non working macros and/or ask question on how to fix them.
The requirements to post a macro are:
MUST be a working macro.
No Pseudo code
AHP version
A narrative
Run from PC or Interface
Keep post similar in format as below:
Narrative:
AHP 3.206
Runs from the interface
This macro turns on a wall switch module that i have a floodlight hardwired to. It is triggered by an Active Eye that I have in my driveway assigned to house/unit code E1. Since I have a large driveway, I have 2 active eyes out there both set to E1. Flag 2 is used to reduce the number of times the F1 On command is transmitted on the powerline so I don't flood the powerline with F1 on commands. The delay in combination with the flag will let the macro run once every 10 seconds.
Macro Name:
Flood Drive On E1
Trigger & Conditions:
E1 On and
Flag Status Off exactly 2
Actions:
Set Flags [2] Flag Command
(F1) Flood Driveway WS467 ON
Delay for 10 Seconds
Clear Flags [2] Flag Command
Note: This info may be cut and paste from the macro reports to save you time in creating the post!
Extra info may be supplied! EG: pics
Much thanks goes out to spam4us for his suggestions\example and input!
If you feel the need to post a question in a macro thread please keep it directed to the one the original poster and stay on topic!!