X10 Community Forum
🖥️ActiveHome Pro => Smart Macros => Plug-ins => User-Designed Working Macros => Topic started by: steven r on October 28, 2007, 11:08:31 PM
-
While these are the simplest macros that I have, they have proven to be a pair of the most useful ones.
Narrative:
AHP 3.204 (Should run from all versions without a problem.)
Runs from the CM15A interface.
This pair of macros allows me to turn ON and OFF window fans from my bedside controller without the fans being being turned off by an "ALL OFF" command.
HC "C" is my primary HC for my house so I have a bedside controller to control all 16 UC. I wanted to be able to turn on and off fans that I have on HC/UC "H14".
Macro Name:
Window Fans ON
Trigger & Conditions:
C14 ON
[no conditions]
Actions:
H14 ON
Macro Name:
Window Fans OFF
Trigger & Conditions:
C14 OFF
[no conditions]
Actions:
H14 OFF
This simple redirection results in a slight but in my opinion negotiable delay for the convenience it offers.
Similar command redirection macros can also allow a simple button remote to control modules in more than one HC.
-
Sorry, but I don't understand the logic here. Why would you require redirection using a macro to control a device? I have multiple Transreceiver modules running at different House Codes and then I have a remote and I can control all my devices individually.
-
I have a bedside controller set to HC "C" as most of the lights in my house are on HC "C". Since I don't want the fan to be turned off with an "All Units Off" for HC "C", I put the fan on HC "H". For convenience should I want to control the fan I can use the macro above by sending a C14 ON or C14 OFF. (The same would be applicable for using with a remote.)
Redirection can allow a remote to control things that are on more than one HC. e.g Suppose You had a radio set for B2, a fan set for C4. One remote could be used via redirection to control both items.
Even in a case where one may have all their lights on one HC, it can come in handy. e.g. Let's suppose you have two kids with lights on C2 and C7. A simple button remote that only controls two sequential UCs couldn't be used to control both lights if it was set as HC "C". You could set the remote as HC "B" and create sequential macros that could control the lights.