X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: PajamaGuy on January 30, 2008, 11:56:08 AM

Title: WS467 (a.k.a. LM14A) will not respond to PalmPad
Post by: PajamaGuy on January 30, 2008, 11:56:08 AM

This is weird - I have 2 WS467's (both soft-starts and both identified as LM14A's) D7 & D8.  They respond to AHP macros.  D7 responds to DIM-Bright commands from a PalmPad, but D8 does not.  ???

Any suggestions?

Title: Re: WS467 (a.k.a. LM14A) will not respond to PalmPad
Post by: dave w on January 30, 2008, 12:33:04 PM

Is the CM15A acting as your (only) RF to PLC tranceiver?
Can you dim - bri  D8 from AHP?
Does the D8  respond to ON-OFFs from the Palm Pad?
Does the local button on the D8 unit dim and brighten the lights like it should?

Your information does not have enough detail to "guess" whether you have a bad WS467 or a noise -phase coupling problem.

Title: Re: WS467 (a.k.a. LM14A) will not respond to PalmPad
Post by: PajamaGuy on January 30, 2008, 12:44:21 PM

Only a CM15A and a DS7000 in the system.  I've had the CM15A set to tranceive Specific "D", Auto, and None.  No change.
I need to verify the ability of the AHP module slides to Dim-Brighten...
I think D8 does NOT respond to On/Off, but will verify it, and D7 as well.
The local button on D8 DOES act correctly Off/Resume/Dim/Brighten.
I have no phase coupling issues so far and real LM465's on that circuit operate from all controls correctly.

Thanks...