X10 Community Forum

📸Cameras & Camera Software => Camera General Discussion => Topic started by: Fschul on February 10, 2008, 08:28:10 PM

Title: Motion sensors
Post by: Fschul on February 10, 2008, 08:28:10 PM
Hi, New to x10.
 Installed 2 camera sys w/motion sensors(2). Had a problem with detection of sensors change house codes on power supply from camera and video receiver from A to D. One Camera has house D and 1 other has house D and 2. Also changed the switch on both cameras to last position from the factory set.  Do I need to change codes on motion sensors to match cameras ? Not sure how to do that. Any help would be great.
Title: Re: Motion sensors
Post by: Fschul on February 11, 2008, 02:06:30 PM
After doing a lot of reading I found my answer from another post. Should have done this before this post, but as like anyone else looking for the quick answer. Thanks anyway :)