X10 Community Forum

💬General Category => General Discussion => Topic started by: nitrocat on February 10, 2008, 09:56:22 PM

Title: VCR Commander not giving the record signal
Post by: nitrocat on February 10, 2008, 09:56:22 PM

After I got the commander programed and it gave me all the right signals that meant it received them, it still wouldn't turn the record cycle on in my VCR. So I took the emitter off the VCR and put it in front of my night vision camera with infrared (that I bought some wear else) to see what the commander was transmitting. It would give the stop signal after about a minute but never the record signal.
Everything else works fine. I can see the cameras on my TV and they jump from camera to camera as motion is sensed by the sensors. Anybody have any suggestions?