X10 Community Forum

🔌General Home Automation => Automating Your House => Topic started by: rjuch on February 13, 2008, 08:01:04 AM

Title: RAIN8 stops responding
Post by: rjuch on February 13, 2008, 08:01:04 AM

Hi Guys,

I have a Rain8 controlling 2 sprinkler zones.  I use the 1 sequence setup to put zone 1 on for 15 minutes and zone 2 on for 25 minutes.  Initially the rain8 responds fine to an I14 ON command (Sequence 1).  The sequence runs perfectly and stops at the end.  But then will not respond to anymore on commands to the sequence on or individual zone on commands ... I have to turn the power off and back on to the transformer and the device will then respond again to on commands ...

Any ideas ?

Regards

Richard