X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Wish List => Topic started by: slimyosra on April 22, 2008, 07:27:11 AM
-
Hi all,
I wanted to know if there is a device that get the temperature of a room and send it to a CM15Pro module via RF?
my goal is to get a system to control each room separate.
Thank you for your help.
Regards
Slim
-
I wanted to know if there is a device that get the temperature of a room and send it to a CM15Pro module via RF?
That is something I kicked around a couple of years ago. I had considered modifying a X10 motion sensor to act as an environmental sensor. I am not aware of anything like that on the market.
Jeff
-
I also have not seen one that used RF and x10 signals.
Smarthome did make a unit called a TempLinc but it used X10 power line signals and a whole House Code. Basically sent a temperature as a house/unit code and a % of dim. Not easy to use and decode with AHP. I believe it emulated one of the automation thermostat status codes.
-
try this site. They have a bunch of solutions for X-10 http://www.x10community.com/forums/index.php?action=post;topic=15105.0;num_replies=2
-
try this site. They have a bunch of solutions for X-10 http://www.x10community.com/forums/index.php?action=post;topic=15105.0;num_replies=2
This is bad link. It goes to a message post option.
-
Here is the correct link http://www.smarthomeusa.com/Shop/Climate/
Not sure why last time it posted the wrong link...hmm :'(