X10 Community Forum

📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => PanTilt Pro => Topic started by: cyclonex10 on May 08, 2008, 11:10:28 PM

Title: Stop Ninja from Center after power outage?
Post by: cyclonex10 on May 08, 2008, 11:10:28 PM

Is it possible to stop the Ninja from centering after a power outage? I followed the procedures in the instructions that I thought addressed this issue but have had no success in stopping the centering after power is restored from an outage.

Thanks for your response in advance.

Title: Re: Stop Ninja from Center after power outage?
Post by: Tuicemen on May 11, 2008, 05:19:20 PM

This is hard coded into the ninja! ;)
If you have Active Home Pro you could make a power restore macro which would reset your cam to the position you'd like! ;)

Title: Re: Stop Ninja from Center after power outage?
Post by: zach1234 on May 12, 2008, 12:10:50 AM

Quote from: Tuicemen on May 11, 2008, 05:19:20 PM

This is hard coded into the ninja! ;)
If you have Active Home Pro you could make a power restore macro which would reset your cam to the position you'd like! ;)

Thank you tuiceman too bad you cant give more than one HELPFUL a day (I all ready gave you one). I was waiting for this to be answered.