X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: mattie on May 16, 2008, 05:51:49 PM
-
get my cameras to mate up with this system? I have the Vangaurd system with 2 XX20A B&W ,and 2 XX16A Color, with 4 MS14A motion sensors hooked up to my PC with the VA11A and the VR24A. I can get one to mate up with a good picture and thats it.
I have them all set with the same HOUSE "A" and then each camera is set up with a different UNIT "1-4". When I switch the VR42A button on the bottom from A to D it will pick up another camera but it wont keep a good connection. All fuzzy and it wont go to a live feed. Like I said..I can get House A Unit 1 to connect with a good picture and thats the only one.
I tried to ask this in the wireless camera section but not to many guy there were familiar with the Vangaurd system.Thanks in advance
-
Well, I am guessing you aren't able to switch threw cameras?
If so you need a Active home interface or a transceiver (alarm consol works too).