X10 Community Forum

📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Multview and Webview => Topic started by: ebox on October 02, 2008, 09:33:10 AM

Title: Multiview does nothing but crash!
Post by: ebox on October 02, 2008, 09:33:10 AM
How the heck do you connect an Xcam2 wireless camera to a PC??????????????????????????  No I dont want to connect it to a TV or VCR, I can get that to work, but no videos posts etc on connecting to a PC.

I have the following hardware:

VA11A USB Video Adapter -----------------> I connect to my PC once after I installed the driver. Device manager shows it is connect on XP, 98, ME etc... so that side works
VR36A Video Receiver -----------------------> I connect this to using a the supplied short male to male RCA jack to the VA11A USB Video Adapter. I then plug in power to unit.
IXX20A Xcam2 Camera------------------------> I power the camera up, and put it on the table next to my computer right beside the VR36A Video Receiver

I installed X RAY and WebView I see absolutely Nothing once the apps are launched. What am I doing wrong. When I install and launch Mulitview...it does nothing but CRASH!!! But I see thats nothing new reading the forum.

I'd appreciate any kind of help on this.