X10 Community Forum

🛡Home Security => Problems and Troubleshooting => Topic started by: SLLIMBRI on October 07, 2008, 12:59:54 AM

Title: DUAL MOTION FLOOD LIGHT
Post by: SLLIMBRI on October 07, 2008, 12:59:54 AM
I'm at my wits end. This is my third flood light in a year. This light never turns off. I have tried the reset no less than 10 times. the lights are always on.

I remember seeing something about which bulbs to use but i don't remember the specifics. could this be my problem? Do I need to get a mini controller to turn them off?

 I have the light connected to a normal light switch that i use to turn it off now. Also, I thought the first unit i had had the sensor on a horizontal post. Now this one is on an angle post that aims the sensor down. the range doesn't seem to be as good with this unit.

It is sending a signal to my alarm in the house because i can hear it go off. I just can't get those darn lights to turn off.

Any suggestions? ???
Title: Re: DUAL MOTION FLOOD LIGHT
Post by: joshz on August 18, 2009, 01:32:29 AM
Did you ever find out what was wrong with your floodlight? I'm having a similar problem to yours. However, my floodlight will shut itself off sometimes, only to turn itself back on shortly afterwards with no motion detected. Really weird problem.
Title: Re: DUAL MOTION FLOOD LIGHT
Post by: SLLIMBRI on August 18, 2009, 09:01:25 AM
I never was able to fix the x10 light. What I did was go to Home Depot and buy a motion light detector. Then I added it to my x10 light by disconnecting the wires to the lights and connecting the new detector. I wish x10 sold the detector only but I have never seen it. I think the concept of x10 is great but the quality is poor. I have several non x10 motion lights that work flawlessly all the time. But my x10 security system is very flakey, even when the sun shines on it.