X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: tuckerssb on January 03, 2009, 06:23:16 PM
-
I originally had a transceiver module, wall switch and eagle eye. we had a lightning strike which killed the transceiver and wall switch.
I upgraded to AHPro, and a new dimmable ws467.
I cannot get the ws467 to respond to commands sent from the eagle eye. I have put fresh batteries everywhere, checked codes in eagle eye and still have no luck. Both the eagle eye and the ws467 are set to F2.
help??
-
In AHP. Tools tab. Hardware Interface Configuration. Make sure that your F House Code is set to be Transceived. If not the RF signal from the motion sensor will never be sent over the power line to the wall switch. Mine I believe defaulted to Auto and only A was enabled.