X10 Community Forum

📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: Catfish on January 24, 2009, 05:23:50 PM

Title: Ninjas Won't switch
Post by: Catfish on January 24, 2009, 05:23:50 PM

>*< I have 2 [two] ninja pan and tilts w/cams, receiver set to freq B, and 1 TM751. All cams are set to proper codes, freqs and chanels. With all cams and tm751 plugged into the same outlet, the cams won't switch. ??? Any Help? *None from X10. Imagine that!*

Title: Re: Ninjas Won't switch
Post by: HA Dave on January 24, 2009, 07:03:09 PM

Quote from: Catfish on January 24, 2009, 05:23:50 PM

.....All cams are set to proper codes, freqs and chanels. With all cams and tm751 plugged into the same outlet, the cams won't switch.

By "All cams are set to proper codes" do you mean the cameras are set in a group of four? With camera one being Unit/House codes say: C1, and the second camera C2, and the third C3?

Title: Re: Ninjas Won't switch
Post by: Brian H on January 24, 2009, 07:27:29 PM

What remote are you using. I did not see your listing one.
As mentioned all the addressable power supplies have to be on the same house code and in a group of four unit codes. 1-4;5-8;9-12 and 13-16.
When one in the group is turned on the other three units in that group will turn off.