X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: GregH on April 23, 2009, 10:35:29 AM
-
I have two Macros firing at the same time and their performance is erratic.
Macro - Floods On (Turns on two PR511s), code B1-On
Macro - Gar Out Off (Turns off one Leviton HCM06-1TW), code B2-Off
I have both of them set to go at 10:30 p.m. Sometimes the Gar Out Off macro does not turn off the Garage Outside lights.
Does the CM15A have a problem running two commands at the same physical time?
I'm currently running AHP 3.228 which I had downgraded from 3.236 due to advice from this board. However, I built the house and macros in 3.236. Could that be a cause of some of the erratic behavior?
Thanks for the help,
Greg
P.S. I have the CM15A plugged into one of Jeff Volp's XTB-IIRs. I love that XTB!
-
You know, I usually stagger my macros by a minute and I,ve had few problems. Not sure if I have to or not as I have never done any testing with "same time" macros. You might try staggering the times and see if you get better results.
-
Thanks. I was wondering if that might be an issue. I'll set up some tests and report back here.