X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: nae on March 18, 2010, 01:31:40 AM
-
I just set my system up today and I am getting the same image no matter which camera I click on. If I change to the 4 camera split screen I get the same image in every screen! This is very frustrating. I have checked that they are all on A and set 1-4. Any other suggestions?
-
Since the cameras are controlled by power line signals. You may want to check where your transceivers [TM751 most likely] position and maybe move it around to different outlets.
What model computer controller was in the kit?
-
I have the same issue. At first I saw different scenes on the cameras, now I get only 1 scene on all three I have set up. They all 3 use different addresses: A1, A2,A3. I ha e unplugged the power sources, rebooted, changed power sources, repositioned and prayed. I have the VA11A.