X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: Brandt on March 28, 2010, 05:26:06 PM
-
I would like to paint my activehome motion sensors a flat white to match the interior walls. However I do not care to go out and buy a small can of paint and a paint brush, or a spray can as I don't want to worry about over-spray. What I was thinking was a paint marker. Can anybody recommend anything?
-
Since the motion sensor cases are plastic I would think that one for plastic models would work. Check out this site (http://www.hobbylinc.com/prods/rhe_tes.htm).
Dan
-
ah yes, I remember Testors from when i was a kid...I'll have to check it out...I'll keep this posted.
-
Sometimes the simplest ideas are the best ideas!
I will definitely do this.
r,
eagle
-
FWIW
The paint marker for mounted units is a good idea, but un-mounted units are simple to spray if you mask the lens and the LED with masking tape.
-
FWIW
The paint marker for mounted units is a good idea, but un-mounted units are sipmle to spray if you mask the lens and the LED with masking tape.
The point was I don't want to spray.
-
No, but others might.
I was just pointing out that they are easy to paint. You don't have to take them apart to do a neat job. Spraying the Stick-A-Switch is a different matter.
-
My 2c - first carefully clean with Denatured Alcohol. Any Art Supply and or Hobby Shop store should have Paint Pens. The paint in them 'sticking' well to plastics needs investigation. Although high rent, I have had good luck with Krylon Fusion paint for plastics. Holding up good outside. A product called BullDog makes darn near any paint stick to plastics ( follow directions exactly). Cardboard cutout and masking for overspray? I've sprayed paint into paper Dixie Cups and used model brushes as a work around. Anything interior wise of course is gonna stink alittle.
(http://i184.photobucket.com/albums/x97/Drifttool/CIMG0210.jpg)