X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: BallorMan on June 09, 2010, 09:22:02 PM
-
I have been over this so many times and I don't know what to do. I have created a new macro using a Door Windows Sensor DS10A and have set it to turn on a light every time a door is opened and then turn that light off when the door closes. And it just wont turn on the light, the macro runs inside Active Home every time I open the door and shows that the light has turned on in Active Home. But the actual light does nothing. But if I open the door then turn the light on manually and then close the door the macro runs and the light actually does turn off. B:(
What am I doing wrong here?
-
Is the module a soft start type? Where the light ramps up and down slowly.
http://kbase.x10.com/wiki/Newer_Wall_Switches_and_Preset_Dim
-
Yes its a WS12A module