X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: Squirrel1162 on September 16, 2010, 01:30:10 AM

Title: Stick-A-Switch (SS13A)
Post by: Squirrel1162 on September 16, 2010, 01:30:10 AM

I have lost the instructions on how to program my Stick-A-Switch (SS13A).  Any ideas where to look w/o calling tech support?

Thanks

Title: Re: Stick-A-Switch (SS13A)
Post by: Brandt on September 16, 2010, 01:36:55 AM

there is an X10 wiki somewhere out there...but its pretty much exactly like programming an msxxa motion sensor if you have those...you hold down the top button and it flashes at you and then you start to press it and then it confirms. I think on is house code and off is unit code.

Title: Re: Stick-A-Switch (SS13A)
Post by: anthonylavado on September 16, 2010, 03:43:13 AM

Is this the info you're looking for?
http://kbase.x10.com/wiki/SS13A

Title: Re: Stick-A-Switch (SS13A)
Post by: Squirrel1162 on September 16, 2010, 09:17:56 AM

That was eactly what I was looking for.  Thank you.