X10 Community Forum
🖥️ActiveHome Pro => Mobile Apps => Plug-ins => MyGarage => Topic started by: couped on February 09, 2011, 08:17:54 PM
-
I have purchased MyGarage Pro and it is working good. One thing I would add is the ability to define the camera that the app should use on the server side. I have multiple cameras set up and the garage app always shows the last camera that was active. When opening the app on my phone, it should issue the command to switch to the correct camera. If I don't leave the last camera set to the one pointing at the garage, then I have to open iWatchMobile Pro and switch to the garage cam to see if the door is open or closed. I can't trust the green and red icons in the app as the DS10A is not picked up my CM15A. My V572RF32 can see it, but it can't pass on security codes. If the app had the ability to assign power line codes instead of just a security device, I could make the status lights work too.