X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: Winkman on March 13, 2011, 03:09:26 PM
-
I Have a strange Problem . I have a RR501 laying around doing nothing so i thought i would swap it out with my TM751 just because I figured it was a good thing to do. The tm751 was set to house code B So i set the RR501 to house code B1 . After removing the 751 and adding the RR501 in AHP the RR501 does not Respond or see My Motion Sensors RF Signals. However i can turn the RR501 on and Off with AHP . I dont understand Why . I Would like to use the RR501 .
-
Did you reconfigure AHP so it is set as a 2 way transceiver/appliance module?
Or did you just swap out the units?
If you just swaped the modules that is the issue!
>!
-
I removed the 751 from AHP and then dragged the RR501 into AHP My room . Its default is 2way Transceiver/appliance module
-
Did you empty the AHP recyle bin and then update the interface?
-
No That I Didnt Do ! Ill Give That a Shot
-
That Was the Problem ! Its working fine! >! Thank So Much !!!!
-
No Problem!
It's usually the simple things we tend to over look!
>!