X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: longbow22 on October 18, 2011, 05:17:38 AM
-
All of the sudden a couple of my lights stopped working via a macro.
I have 2 outside lights, 1 on the front porch, 1 on my garage.
I can trigger both of these lights manually via a remote just fine, both lights will turn off when they are supposed to.
This all started when I updated my AHP to the latest version on this site, I guess I could revert back to the old and see what happens.
Just dont make sense that I can turn them on via a remote, and they will turn off automatically when they are supposed to, but they will no longer turn on when they are supposed to.
Thanks
LB
-
Are the switches old enough to not be soft start? They go On and Off rapidly and not ramp On and Off.
Later AHP versions added a new module type choice tab. Called Old Lamps (no soft start).
If you switches are not soft start. Redefine the problem switches from the Old Lamp (no soft start) list.
-
Yes I caught that.
I did notice this morning that after I upgrade to the current version and went into ALL my macros where I had a switch turned on followed by a delay ( 5minutes) and then off. ALL the switches that were supposed to be on had the off option set so it was off, wait 5 minutes off again.
I changed them all back to on as before and it looks like my problem may be resolved.
Thanks for the reply.
LB