X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wired Cameras => Topic started by: HighlanderCFH on January 03, 2012, 02:28:40 AM
-
Greetings,
I just joined the forums after purchasing many items from X10 over the years. I just received an order for a NightWatch 2, model SC23A.
It was pretty easy to install outside so I can watch down the street when expecting company or a delivery, etc.
I have 2 questions. The first is that since I began using the camera, I've noticed that it shuts off after being on for a while. After I simply unplug the power supply & plug it back in, it comes back on again. Could I be doing something wrong to cause these shutoffs? Or could there be some defect involved?
My second question is whether I'm supposed to keep the clear plastic lens cap on or remove it.
Thanks for any help that anyone can offer.
Chuck
-
Check what X10 address the power supply is set to.
Cameras work in groups of four Unit Codes in the same House Code. Turn one On the other three go Off.
Unit Codes 1-4,5-8,9-12 and 13-16.
If you have any other X10 equipment using any of the four Unit Codes. They could be turning them Off.
Don't overlook motion sensors that use the next higher Unit Code for their dusk dawn detector.
By default when powered up. The camera is On so you are turning it On after something maybe turning it Off.
-
Check what X10 address the power supply is set to.
Cameras work in groups of four Unit Codes in the same House Code. Turn one On the other three go Off.
Unit Codes 1-4,5-8,9-12 and 13-16.
If you have any other X10 equipment using any of the four Unit Codes. They could be turning them Off.
Don't overlook motion sensors that use the next higher Unit Code for their dusk dawn detector.
By default when powered up. The camera is On so you are turning it On after something maybe turning it Off.
This helped me a lot. Thanks Brian.