X10 Community Forum
💬General Category => General Discussion => Topic started by: BoyntonStu on March 15, 2012, 11:45:49 AM
-
If one could bypass/eliminate the detector and switch control the MS16A it could be used as a switch sensed transmitter.
AAMOF I would like to only send the receiver an OFF signal and have the appliance remain OFF.
EDIT: Another possible solution is to use the dawn/dusk control.
Instead of just closing/opening a switch, use the switch to turn on a little bulb.
Is the dawn/dusk sensor the whole sensor or just a small portion?
Is this a project too far a reach?
-
This isn't Twitter, you can use more words without penalty.
If I understand your desire, you want to use the motion sensor to send X10 ON-OFF commands from a contact closure trigger. You can use " Dawn/Dusk" feature /circuit to do this. You substitute the closure for the Cadmium Sulfide cell in the MS16. When the contacts are closed the MS16 will send an OFF command. I believe you can swap this action by cutting a jumper on the board.
http://www.laureanno.com/x10-mod1.html.
When contacts open it will send an ON. The mod for the MS16 is simple if you can drive a soldering iron.
You CAN NOT send only OFF commands.