X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: tom j on March 27, 2012, 02:43:06 PM
-
Hello my sister just got a new Nettalk devise and was wondering if there's any reason it wouldn't work with a PS561 the PS561 is dialing out analog and not digitally. I assume the 61 is capital of handling 11 digit numbers 1-xxx-xxxxxxx so I'm looking for someone that may have one and using it with success with the Nettalk Duo. thanks guys!!
Tom
-
Can't figure out whats going on here and hoping someone can help got it hooked up to my sisters system but it wont dial her cell phone. If I pick up the extension I can hear the various dial tones but then I hear a busy. This seems to indicate the system did not properly dial out. For example the Duo requires you to dial 11 digits, 1 the then the area code and finally the number. If for example you just dial 10 digits or dial improperly you get a busy signal like I'm hearing now so I'm just wondering whats not being translated. Hoping someone can help.
Tom
-
Can you set up Net Talk to accept "short" DTMF tones?
Since you can't program a pause in the PS561, try putting an extra leading "1" in the first dial out number just to see what happens. As I recall the PS561 starts dialout immediately after coming "off hook". This may be too fast for Nettalk. $0.02
-
Can you set up Net Talk to accept "short" DTMF tones?
Since you can't program a pause in the PS561, try putting an extra leading "1" in the first dial out number just to see what happens. As I recall the PS561 starts dialout immediately after coming "off hook". This may be too fast for Nettalk. $0.02
Hi Dave thanks for chiming in! do you think that might be the problem? anything else you can think of I'm going to call support tomorrow. I did read after doing a search here that someone has one successfully connected to a SC1200 is there any difference in the dialer between those two as far as you know. Thanks again for your support.
Tom j.
-
Say Dave one other thing I noticed was that if I pick up the phone it seems like the the PS561 was unable to open the line to dial. if I pickup the phone during the dialing sequence I hear a dial tone. Any idea what could be causing this and hopefully a possible solution. Thanks!
Tom