X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: raog on April 09, 2012, 03:16:14 PM
-
Hello Guys,
I read all of the posts related to this issue, but I think this is new. I configured my Sc1200 with two magnetic contacts. After a while the LCD show me that zone 4 is low battery, but there is no zone 4. I just did a master reset and then configured it again. Again, one day later the same thing. I noticed that this start when the not configured zones randomly start to blinking. Does anyone know how to correct this?.
-
Do you have DS10A or DS12A Door Window Sensors?
Is the zone showing Tamper one that is installed or also a fantom zone?
-
Hi Brian, Accordinly with your questions.
I have installed DS10A. The zone that showing the tamper is a phanton zone.
-
The DS10A does not have a tamper switch so it should never show that message.
Since the SC1200 seems to be showing zones you don't have and problems in the zones you don't have.
I suspect the SC1200 Console maybe defective.
You may want to try calling or emailing X10 Customer Support.