X10 Community Forum

📸Cameras & Camera Software => AirSight Cameras => Topic started by: jbchannell on June 04, 2012, 11:07:17 AM

Title: Airsight H.264
Post by: jbchannell on June 04, 2012, 11:07:17 AM
What battery and solar panel is needed to power an Airsight H.264 24/7 365 days.
Title: Re: Airsight H.264
Post by: Tuicemen on June 04, 2012, 12:15:10 PM
This will depend greatly on your location and how much sunlight you get on average a day.
In general (for NorthAmerican sites) you'll get less sun in winter months. This means you'll need a larger battery capacity for that time of year.
There are several solar web sites and or forums that can make recommendations based on power requirements needed and your location.
 >!
Title: Re: Airsight H.264
Post by: jbchannell on June 05, 2012, 11:02:11 AM
I live In Tennessee where there is an average of 200 days with sun. A solar farm was just installed near me so there is ample amout of sun. I understand the need to size the battery and solar panel based on location in the country but I have no means to do that. Thanks for your reply.
Title: Re: Airsight H.264
Post by: dave w on June 05, 2012, 12:18:14 PM
I live In Tennessee where there is an average of 200 days with sun. A solar farm was just installed near me so there is ample amout of sun. I understand the need to size the battery and solar panel based on location in the country but I have no means to do that. Thanks for your reply.
The camera draws 7 watts. Armed with that I would take Tuicemans advice and find a solar power forum and ask there. My WAG would be a panel at least four to six times larger than the power draw, with a battery that would run the camera 24 hours before discharge which would be something on the order of 12 amp hour minimum. I have no experience with solar so may be shooting way high. A good reason to find a forum where knowledgable folks working with solar may save you a couple hundred bucks.

Also, the camera runs on five volts but your solar panel and battery output 12V. So you will need to build a 5V voltage regulator to reduce the battery output down to 5V DC. Some charge controllers have a 5V output.