X10 Community Forum
📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Wireless Cameras(non IP) => Topic started by: photoman63 on July 21, 2012, 10:15:19 PM
-
II just bought the XX36X wireless/wired cameras. I have set it up on my Mac but I installed it on VMware Fusion. I was able to get it to work when it was connected to my wireless router but I do not see in the manual how to get it to work with just wireless. I an guessing that it should world just like a laptop on a wireless network but if I disconnect the power and the cable from the hub I get nothing. What am I doing wrong.
Thanks for any help in advance.
-
Well I was able to figure it out and it is working just fine now. Only thing left is to see if I can log in from my iphone 4s
-
#:) I am having that problem. What did you do to fix it? :)%
-
#:) I am having that problem. What did you do to fix it? :)%
You probably have your wireless settings entered incorrectly. I would double check your encryption and your share key first. If you use WEP, try switching to WEP 128 bits. Wireless Setup Walkthrough (http://kbase.x10.com/wiki/IP_Camera_Wireless_Setup)
Well I was able to figure it out and it is working just fine now. Only thing left is to see if I can log in from my iphone 4s
Have you set up port forwarding with your router?