X10 Community Forum
🛡Home Security => Problems and Troubleshooting => Topic started by: Andytec on August 12, 2012, 01:56:46 PM
-
I can install a remote on the console (1) but then it wont respond to remote commands. The remote works fine with another console (2) and the console (1) works with the first remote it accepts. Batteries are new.
Any suggestions as to why ? IS there a limit to additional devices after which the console will act like it has accepted a remote ( install Beep) but actually it has not accepted its install code ?
-
Knowledgebase says eight or less remotes.
http://kbase.x10.com/wiki/Eight_Remotes_Sixteen_Sensors
You want to use one remote registered to two consoles correct?
The functions that don't work are like Arm and Disarm?
-
Thanks Brian
I reprogrammed everything from scratch and it worked fine then - dont know what caused the glitch
Andy