X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: Gismo on September 06, 2012, 07:36:01 PM

Title: Lamp module noise problem FIXED
Post by: Gismo on September 06, 2012, 07:36:01 PM
Ok, for the last month my lamp modules we not going on or off when scheduled thru my CM15A or my old Radio Shack (wired) mini controller. The wierd thing is that it just started, they worked for years. I tried everything, I was going nuts to figure it out..  Well after I was ready to give up something told me to unplug my LED power falure lights. But I figured that could not be the problem, because I had them for 2 years, but i remembered I just bought 2 new ones a month ago. So I unplugged the new ones and bingo......everything back to normal. 

The units that I had for 2 years were the Eco-i-Lite Power Failure LED Light  model NF-L200 they never caused a problem.

The ones that are going bye-bye are the Eco-i-Lite Power Failure LED Light  model NF-L400 the evil little buggers.

Now I can get back to normal....or until something else causes interference.

I hope this helps anyone that has those power light units and x10 interference.
Title: Re: Lamp module noise problem FIXED
Post by: Brian H on September 06, 2012, 07:46:24 PM
Good catch.
Sometimes we overlook something new we added to our home or we moved something to a different location.

Also occasionally something deteriorates as the years go by and now cause problems that didn't happen originally.