X10 Community Forum
💬General Category => General Discussion => Topic started by: rjniles on September 16, 2012, 01:03:28 PM
-
I have a 3 pin appliance that stopped working. When I send an on command, it will flash but will not hold on. I tested with a lamp plugged it: the lamp flashes every time I send the on command but will not stau on. Any fix for this?
-
I have a 3 pin appliance that stopped working. When I send an on command, it will flash but will not hold on. I tested with a lamp plugged it: the lamp flashes every time I send the on command but will not stau on. Any fix for this?
It sounds like the relay position feedback circuit has failed.
http://forums.x10.com/index.php?topic=18964.0
-
Yes Pulses a few times is the On Off status circuit.
How old is it. The real new CFL friendly ones use a different circuit from the older ones.
-
I opened the case and found a large black burn mark on the circuit board (the magic smoke was gone). I tossed it.
-
If you where adventurous. There are some schematics of the older model hardware devices floating around.
Though if the magic smoke is gone. Hard to say if resuscitation would be possible.