X10 Community Forum
🔌General Home Automation => Automating Your House => Topic started by: Eddie_T on November 19, 2012, 11:16:05 AM
-
Can the PLW02 3 way wall switch be used without a companion slave switch as a single point switch?
-
You should be able to use a PLW02 without the slave.
Connect the Black wire of the Master switch to the 120 volt Line
Connect the Blue wire from the Master switch to the Load.
Tape or cap off the Red wire from the Master switch and it is not used.
-
Thanks much! I had a chance to buy the switch at a much lower price than a WS467 which needs replacing.