X10 Community Forum
📸Cameras & Camera Software => AirSight Cameras => Topic started by: AMBERMUMA on February 11, 2013, 06:41:12 PM
-
I RECENTLY RESET MY AIRSIGHT CAMERA, AND NOW I CANT CONNECT TO THE CAMERA WITHOUT A CAT5 CABLE. I SCANNED NETWORK, CHOSE MY SSID, PUT IN PASSWORD, AND THAN UNPLUGGED IT WHILE IT'S REBOOTING, BUT IT FALLS OFF THE NETWORK AND WONT COME BACK ON UNTIL I PLUG IT BACK INTO ROUTER. I HAD IT CONFIGURED BEFORE THE RESET AND IT WORKED FINE. I EVEN TRIED WAITING A FEW MINUTES AFTER THE REBOOT TO UNPLUG, AND STILL NOTHING
-
Please do us a favor.
Don't use all capital letters in your posts. Harder to read and considered shouting.
-
Search the forum for "(camera model) wireless connection".
-
I RECENTLY RESET MY AIRSIGHT CAMERA, AND NOW I CANT CONNECT TO THE CAMERA WITHOUT A CAT5 CABLE. I SCANNED NETWORK, CHOSE MY SSID, PUT IN PASSWORD, AND THAN UNPLUGGED IT WHILE IT'S REBOOTING, BUT IT FALLS OFF THE NETWORK AND WONT COME BACK ON UNTIL I PLUG IT BACK INTO ROUTER. I HAD IT CONFIGURED BEFORE THE RESET AND IT WORKED FINE. I EVEN TRIED WAITING A FEW MINUTES AFTER THE REBOOT TO UNPLUG, AND STILL NOTHING
After reading your post, i tried doing what you did, unplugging my CAT5/POE CABLE, and to my surprise, it acted like yours.. could not connect wirelessly, but could as soon as i plugged the CAT5 back.
So, this is what i did....
I cleared my router ( Factory reset ) which screwed that up so i had to reset ( use the CD ) to start over.
Before i started... i unplugged the CAT/POE cable from the camera..don't for get the power if you re just using a CAT5 CABLE and Power Plug. Unplug the power from the camera too.
I rebooted my computer then restored my router to the original settings.
Then plugged up only the power back to the camera ( left CAT5 unplugged) and ran the IP Camera tool which instantly brought up the IP address before the screw up BUT
It is now working wirelessly as i type this.
FYI.
Before the unplugging CAT5, i had set my camera - Obtain IP from DHCP Server
I then, unchecked the box Obtain IP from DHCP Server
Reboot computer and alls well that ends well... so far.
-
BTW, does anybody else noticed we are getting at lot of folks who start a post and never come back? It's becoming an epidemic.
-
BTW, does anybody else noticed we are getting at lot of folks who start a post and never come back? It's becoming an epidemic.
Yes, I see same. But is mainly cameras, now that tablets have been dropped by X10. With cameras, tablets, and even security systems, if their problem gets solved, there is little reason to come back to the forum. It would be nice if they would indicate if their problem got fixed.
Automation on the other hand, encourages return visits because it can constantly expand (there is always something that can be automated) .