X10 Community Forum
📸Cameras & Camera Software => AirSight Cameras => Topic started by: Cleaveland on February 21, 2013, 02:38:05 PM
-
We have an Airsight Xc36A (Firmware 17.37.2.41, UI 17.37.2.41) with some issues:
During operation (not scanning) it sometimes re-aims to a different place. We haven't seen it happening but I suspect it's a reboot. We have the "call the preset position" disabled. This happens several times a day. We have experienced no problems with the power source. Any suggestions?
-
I have found my XX40a camera doing that within the last few days.
It seems to only do it when my computer may go into power saving mode and i wake up the computer again.