X10 Community Forum

📸Cameras & Camera Software => AirSight Cameras => Topic started by: speedwiz on February 05, 2014, 11:12:35 AM

Title: Firmware request - XX59A
Post by: speedwiz on February 05, 2014, 11:12:35 AM
I searched and could not find that.
Need firmware for XX59A

Many thanks.
Title: Re: Firmware request - XX59A
Post by: Tuicemen on February 05, 2014, 11:34:33 AM
You should be able to hard reset the camera to its last firmware.
With X10 servers down and no clear idea as when they'll be back up you might look to the manufacture.
Which was apparently http://www.apexis.cc/
Comparing specs you may find the firmware which will work as there are 3 pages of downloads available and several of these are firmware updates.
 >!
Title: Re: Firmware request - XX59A
Post by: speedwiz on February 05, 2014, 05:48:29 PM
Many many thanks.
In fact, Apexis H803 and XX59A appears the same hardware as H803.
But that firmware have the same problem here. Cannot find my APs, and when found, donīt connect. Mac Address donīt appear on router.
By ethernet works fine.
Title: Re: Firmware request - XX59A
Post by: Tuicemen on February 05, 2014, 06:16:32 PM
Some router/modems won't display a mac address for all devices you have to manually enter it.
This was the case for my android phones on my router.
Title: Re: Firmware request - XX59A
Post by: speedwiz on February 05, 2014, 06:33:33 PM
I will try to force bind IP with Mac, but it worked before.
Mac Address appear in ARP table on ethernet connection but not on Wireless

Tested in 2 routers. A TP-Link WDR3600 and a Cisco E2500 with DD-WRT. Neither works

Thank you for help me.

EDITED: Good news. Working now. Reflashed with 91.2.5.68bk (APM-H901 model) firmware and 1.14.5.37 webUI.

Issues: After reflash, only E2500 in AP mode recognizes camera. in Repeater Bridge fail.
Reset Factory and configured again as a Repeater Bridge. Now cam appear on Wlan Mac Address Table and worked.
TP-Link router or my TP-Link extender donīt recognizes camera. Factory reset and reconfig
After 3 factory resets, both recognizes camera.
This firmware has a problem. Everything works but PT no.
Title: Re: Firmware request - XX59A
Post by: Tuicemen on February 06, 2014, 07:00:29 PM
Glad to hear you have your cameras back.
You may wish to contact apexis support to see if there is a firmware update in the works and explain your issue.
X10 has stated they are planning to bring back Air sight cameras but these will be from a different manufacture so I don't expect the firmware to work with the older cameras.
Nor do I suspect they will support the older ones.
 >!
Title: Re: Firmware request - XX59A
Post by: speedwiz on February 07, 2014, 05:12:17 AM
Tuicemen,

Thanks for your help. Camera is back, with Pan/Tiilt using APM-H803 firmware. I think there are some bugs on TP-LINK routers. On DD-WRT firmware in AP mode camera was found. On TP-LINK not. Needed hard reset WRD3600 many times until camera appear on wireless statistics and connect. After this, itīs operating well.