X10 Community Forum

📸Cameras & Camera Software => Legacy non Wi-Fi X10 Cameras => Camera General Discussion => Vanguard Internet Control Center => Topic started by: renchr01 on April 14, 2014, 06:51:24 AM

Title: software
Post by: renchr01 on April 14, 2014, 06:51:24 AM
My computer crashed and I had vanguard on it. How do I go about getting the software to run my cameras. I tried the link when I first installed them but that link no longer works. Any help out there as to what to do? I would very much appreciate it B:(
Title: Re: software
Post by: Tuicemen on April 14, 2014, 08:11:23 AM
Since the servers are still not operational all the old x10 software is unavailable.
You might try PC Companion, ihouse or ispy for x10 camera viewing.
I've recently updated PC Companion to include extra controls for vanguard/sentinel cameras
Title: Re: software
Post by: renchr01 on April 14, 2014, 10:40:13 AM
is there a link for pc companion tuiceman. Is this the only thing that is needed to get my system up and running again? Or do I need drivers for the various things. CM19A, CR12A, MS14A, TM751, VA12a, and the X10 cameras
Title: Re: software
Post by: Tuicemen on April 14, 2014, 11:47:27 AM
oops :-[ forgot to add links.
http://www.tuicemen.com/pccompanion/pccompanion.html
The other links can be found on my forum (http://tuicemen.com/forum) or in the AHP third party software section here
Title: Re: software
Post by: renchr01 on April 14, 2014, 12:16:02 PM
Thanks tuiceman
 >!