X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Help & Troubleshooting => Topic started by: bt54 on April 20, 2016, 10:27:31 PM
-
My first floor lights have stopped working from my Palmpad (3 wall switches and a lamp module). The switches manually work. I'm looking at the Activity Monitor and one Light Switch on another floor is receiving a never ending flow of Receive signals. I pulled the batteries from all of my Palmpads and that did not stop the signal. I also cm15
cleared the memory on my CM15 and then reprogrammed it.
Signal Code is: Date\Time Receive L16 (Garage Door Light)
Does anyone have any idea what is happening?????
-
Is L16 a valid X10 address being used in your system?
Do you have any X10 Coupler Repeaters in your system.
The Activity Log is showing power line or RF L16 commands?
-
Brian,
Thanks for the reply !!!
L16 is a Valid Address. I have a repeater that I didn't think of and checked it after I made the post. I replaced it with another repeater and the flood of signals stopped but I think the "new" repeater has problems as it is sending mixed signals. I pressed L9 on the Palmpad and L9 & L10 were activated. My basement (where the repeater is located) has all of the Light Switches and modules working but my First floor is still not working. I replaced a light module and now it works. I have two wall switches that I'm going to remove and test as they are not activating when signaled.