X10 Community Forum

🛡Home Security => Problems and Troubleshooting => Topic started by: frankie on November 13, 2017, 09:39:41 AM

Title: SC1200 console
Post by: frankie on November 13, 2017, 09:39:41 AM

Where is the install/run switch on the SC1200 console i am trying to install the SH624 remote.

Title: Re: SC1200 console
Post by: Brian H on November 13, 2017, 12:29:44 PM

There is no Install Run switch.
It is all done in the SC1200's Menu's
Here is the full manual for it. On the off chance you need it.
http://www.authinx.com/manuals/X10/SC1200.pdf

Been awhile. I believe it is added like any of the other security remotes.
Try following the SH624 instructions up to the Install-Run switch line.
Then using the SC1200 menu's to Install a Remote.
Using the Arm Button on the SH624 should install.

Title: Re: SC1200 console
Post by: frankie on November 13, 2017, 02:15:25 PM

Thanks Brian I will certainly try that and let you know if it works.

Title: Re: SC1200 console
Post by: Brian H on November 14, 2017, 12:40:55 PM

I did a test with an SH624 and the Radio Shack 49-1000 Console.
It was the X10WTI OEM version of the SC1200 made for Radio Shack.
I was able to add it with no issues.
If you have any problems let us know.

The MIN/MAX switch will allow you to Arm Home or Arm Away. With or without the Exit Delay.
MIN Arms with no Exit Delay
MAX Arms with an Exit Delay. That the delay time can be set. In one of the Menu pages.

The four standard buttons send an On or Off command on the House Code set on the dial. If the consoles House Code is the same. The commands from the SH624 will be put back on to the power lines.