X10 Community Forum
🛡Home Security => Home Security General => Topic started by: haguy on February 28, 2021, 11:37:06 PM
-
I plan to get a hawkeye MS16A, which uses two consecutive house/unit codes for motion and light sensors. (Light unit code = Motion unit code + 1)
Just of our curiosity, what happens if I set the motion sensor address to A16 ? Will the light sensor wrap around to become A1 ?
Or will the light sensor be disabled?
-
The manual does not cover that.
I have seen posts here where it wraps around.
So motion A16, Light would be A1.
-
The +1 unit code for lighting control does wrap around from 16 to 1 on the MS16A, and I've used that in my setup before. The wrap-around also occurs on SS13A remotes, XPT keypad transmitters, and PR511 floodlights, which have triggers for +1/+2/+3 unit codes. Actually, I don't think I've encountered any X10 branded device where the unit code doesn't wrap around.