X10 Community Forum
📱X10 WIFI => 🐞X10 WIFI App problems or bugs => 🏥Help & Trouble shooting => Topic started by: roger hachey on December 26, 2021, 06:07:51 PM
-
Can the WM-100 work with X10 Motion Sensors such MS16A and MS14A? I can't ind any posting on it.
-
Can the WM-100 work with X10 Motion Sensors such MS16A and MS14A? I can't ind any posting on it.
If I'm not mistaken you'd need an RR501 or TM751 transceiver as I don't think the WM100 receives RF signals.
-
I did not see any X10 RF signals receiver in the WM100 manual or sales page. Just connects through Wi-Fi.
You would probably need a transceiver as mentioned. TM751 or RR502 are two.
-
The prototype for the WM100 did have X10 RF capabilities however saddly that was removed before production.
-
I have the whole house tranceiver v572, I don't se any way of configuring the X10 Wi-Fi to run a Moton Sensor when it is triggered
-
The V572 should receive the standard X10 RF command from the Motion Sensor and put it on the power lines.
Can the WM100 receive X10 power line commands and then act on them?