X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: oren hiller on October 14, 2005, 12:03:32 AM

Title: RF124 Isolated Contact Relay
Post by: oren hiller on October 14, 2005, 12:03:32 AM

I woulf like to install this relay to turn
on and off my dishwasher. The Relay has
four wires. Black-Line wire, White -
Neutral Wire, and two blue line labeled
power source and the other labeled load.
Which two wires get connected to the the
black and white wire coming in from the
main circuit box and which two get
connected to the black and white wires from
the dishwasher?  Thanks

Title: Re: RF124 Isolated Contact Relay
Post by: roger1818 on October 17, 2005, 01:00:10 PM

You can download the manual for this module
at
http://www.act-solutions.com/pdfs/PCCInst/RF124_instr%20.pdf

This module is overkill for your needs as it
is intended for situations where the load is
on a separate circuit from the control line,
but here is how I think you would connect it:

RF124   Connecctions
------  ----------------------
black:  black from circuit box
white:  all other white wires
blue1:  black from circuit box
blue2:  black from dishwasher