X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Topic started by: james on November 06, 2005, 06:46:29 PM

Title: Stick-A-Switch Remote Wall Switch
Post by: james on November 06, 2005, 06:46:29 PM
How do you program this to turn off/on
modules?

James
Title: Re: Stick-A-Switch Remote Wall Switch
Post by: james on November 06, 2005, 07:32:17 PM
I got this to turn on/off the controller on
the computer side. But for some reason it
doesn't actually turn on/off the controller
itself. Any ideas?
Title: Re: Stick-A-Switch Remote Wall Switch
Post by: chuck on November 07, 2005, 08:49:55 PM
I have the exact same problem.  I see it
change the position on the AHP software, but
the light does not actually change.
Title: Re: Stick-A-Switch Remote Wall Switch
Post by: dd on November 08, 2005, 05:50:53 PM
I had the same problem... and then one day,
it started just working.  Worked in the
beginning, then not, then now... hoping it
will stay that way!  Wish I could tell you
what changed, cause I don't know for sure.
I think I made a macro, then deleted the
macro, and all the sudden, it worked.
Title: Re: Stick-A-Switch Remote Wall Switch
Post by: Mike C on November 08, 2005, 06:27:43 PM
The Stick-A-Switch works like all other x10
remote control devices. You first have to
program it with a house code and unit code.
You then have to set the hardware
configuration to tranceive that house code
in the active home software. This can be
found in the tools menu. I am assuming that
the light can be turned on or off by
clicking on the module switch in the
software window. The module connected to
the lamp should have the same house code
and unit code unless you are going to be
using the macro feature.
Title: Re: Stick-A-Switch Remote Wall Switch
Post by: X10 Pro on November 08, 2005, 06:40:24 PM
Always make sure that the CM15A is set to
transceive commands from your remote
controls. From Tools
Title: Re: Stick-A-Switch Remote Wall Switch
Post by: james on November 08, 2005, 10:11:39 PM
THANK YOU!
I'm extremely Happy!