X10 Community Forum

🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: lanyu on February 10, 2006, 01:22:05 AM

Title: Stops MACROS
Post by: lanyu on February 10, 2006, 01:22:05 AM
1.May I stop MACRO which carries out
carrying out another MACRO?
2. When carries out MACRO continuously
carries out many movements and Delay, when
store in interface,Cannot normally carry
out.
Title: Re: Stops MACROS
Post by: Tuicemen on February 23, 2006, 10:46:41 AM
 ??? I'll tempt to answer!
Macros in the interface can't be stopped once there started (well if you unplug the CM15A they can) you can how ever stop a macro from starting with conditions.
You say you have a macro starting a macro so you could have a condition in the first macro that would only fire the second if conditions were met.
If you already have all the conditions you can cram into your macro you may have to use flags in place of some conditions, which can expand your conditions. But then you'd be getting into so complex stuff (not that using flags is complex but you can make it so!)  ;) With out knowing exactly what your trying to do I realy can't help. It is posible that placing a phantom module in your first macro would help!  :) ;) ;D
Title: Re: Stops MACROS
Post by: poursha on February 25, 2006, 03:35:45 PM
Good answer TM.  When I first read you post...  "Macros in the interface can't be stopped once there started.."  I almost started a retort..  But, you continued your answer by giving the complicated method. 

Good summary!

RoB