X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: jim lytle on February 04, 2005, 09:52:16 PM
-
I just installed the smart macro plug-in.
I haven't had too much time to play with
it, but one item jumps out at me.
Any conditional that uses dawn or dusk time
setting shows the clock at a little over
two hours later than actual dawn or dusk.
The correct dawn dusk time for my location
is indicated in the Hardware configuration
display.
Am I overlooking some setting that should
have been made? I sure can't find any way
to set this. It seems it should take its
setting from the Hardware configuration.
-
I am having the same issue. My dusk to dawn
timers do not work. I did check the hardware
configuration and it is set for my location.
-
Montsho, when I upgraded to V3.179 this
problem was corrected.
-
I actually think there is a larger problem.
Now none of my timers are working once I
disonnected from my PC. I too upgraded and
now I am having major problems.
-
I also upgraded to the lastest version of
A.H., and I started having some serious
problems as well. Everylight in the house
would turn on full blast for no reason in
the middle of the night waking my wife and
I. Also, none of my macros were stable
afterwards. I had to reinstall version
3.168 and haven't had any problems. My
advice would be to stay with older versions
of A.H. for stability until they fix all
the bugs in their upgrade.