X10 Community Forum
🖥️ActiveHome Pro => Plug-ins => Smart Macros => Topic started by: david k on May 07, 2005, 06:43:14 PM
-
X10Pro
The macro following competely works if RUN
MACRO button is clicked. It runs when
triggered but only turns on the camera,
nothing else.
Is there something I am not getting with
Smart Macros because almost none of them
work if I use conditions, which is why I
purchased it to start with?
PLEASE TRY THIS: (copied from Macro Report)
Trigger condition start:M2 On
Flag Status Off exactly 5 and
Daytime
Trigger condition end:
Set Flags [5] Flag Command
(C2) Camera 2 Select Camera
Delay 5 seconds
Record Snapshot
Delay 5 seconds
(C2) Camera 2 OFF
Clear Flags [5] Flag Command