X10 Community Forum

🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: h j flynn on December 01, 2004, 10:22:19 PM

Title: Moving Module to end of Room Crashes AHP
Post by: h j flynn on December 01, 2004, 10:22:19 PM

XP SP2, AHP 3.170

If you move a module to the end of a room
AHP Crashes

Title: Re: Moving Module to end of Room Crashes AHP
Post by: bebop on December 01, 2004, 11:28:58 PM

Same problem here, although it did it once
and then didn't do it the next time I tried.

Title: Re: Moving Module to end of Room Crashes AHP
Post by: bebop on December 01, 2004, 11:30:58 PM

OK, now it's doing it consistently for me
too!

Title: Re: Moving Module to end of Room Crashes AHP
Post by: X10 Pro on December 02, 2004, 12:51:11 PM

We found this too. It's fixed in the next update.

Title: Re: Moving Module to end of Room Crashes AHP
Post by: h j flynn on December 02, 2004, 03:03:03 PM

X10 support, thanks for you prompt response
and resolution. I would like to say "job
well done" in getting fixes done in a
timely manner with the different problems
that have been reported. At first I was
sceptical and was planning to return AHP
and go back to AH, but your quick
resolutions to the many problems reported
by users and my self have been address
within a reasonable time with enhancements.
I would hope the all users would consider
working toward getting things fixed and
enhancing the product rather than
complaining. Keep up the good work.