X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: donald mcmow on December 03, 2004, 11:39:39 AM
-
Houston, We have a problem - When using a
looped macro with Bright and Dim commands
the module displays the bright as 99% but
does not display the Dim as a -99% (100%).
On the next loop through the number is
reported as the previous number (99%) + the
Bright 99% (new value is 198%) and the
green bar goes outside it's proper display
range. The Dim command is either not
subtracted or is added to the previous
values. This will keep happening until the
loop is stopped. I can send my data file to
illustrate this event if requested. Note
the file also illustrates that you can do a
macro loop - something we were originaly
told was not possible.
-
Forgot my own advice - This worked fine
until I downloaded and installed version
3.171.
-
Donald: Send the file and we'll take a look.
Where do you see the problem with the display
of the dim values -- in Activity Monitor?
-
Activity Monitor reports the values
correctly, the problem happens in the room
view as the macro is executing.