X10 Community Forum
🖥️ActiveHome Pro => ActiveHome Pro General => Software Problems & Bugs => Topic started by: ekraus on December 03, 2004, 09:12:48 PM
-
I am not sure what is going on.
The cm15a seems to work OK whan it is
connected to the PC and Activehome is
running. Disconnect it move it to another
circuit in the house, works fo an hour or
so then Nothing Nada. The macros stop
functioning and the timers dont work. So I
connect it back to the PC. I get Hardware
Not connected. Reboot the PC, Nothing!
I also get an error message that there is a
problem with the USB port. I haven't tried
to remove the bats yet but I suspect it
will clear the memory. Think I got a bad
interface? Or they got some serious
problems with the software/firmware or
hardware.
-
I have the same issue, also uploaded the
new update which did not fix it. Installed
the whole thing on another computer and did
not fix it. I did remove the battery and
did not resolve either.